Page 1 of 1
Lost Surface Roads on 66 st?
Posted: Sun Feb 24, 2019 3:53 pm
by oldcrashtestdummy
New member here, but this seems to be the most active GPS forum that I can find. I have a GPSMAP 66 st that is a couple of weeks old. I'm still trying to figure it out. My map display (preloaded 100K)(USA) is no longer showing the surface roads, only major highways. Have I turned something off that is causing this?
Re: Lost Surface Roads on 66 st?
Posted: Sun Feb 24, 2019 5:15 pm
by GPSrChive
Welcome to GPSrChive!
A few questions:
1. What firmware version is installed on your GPSMAP 66st? [Setup > About]
2. What detail level do you have the Map page set to? [Setup > Maps > Advanced Setup > Detail]
3. What is the Map Page scale displayed when the surface streets are not visible?
4. Do you have any additional maps installed on your GPSMAP 66st?
5. If 4 = Yes, which maps and are they enabled/disabled?
Re: Lost Surface Roads on 66 st?
Posted: Sun Feb 24, 2019 5:50 pm
by oldcrashtestdummy
This helped me figure it out. I had the Configure Maps set to Worldwide DEM Basemap. Changing it to Topo US & Canada brought back the surface roads. Thanks for the help.
Re: Lost Surface Roads on 66 st?
Posted: Sun Feb 24, 2019 5:55 pm
by GPSrChive
oldcrashtestdummy wrote: Sun Feb 24, 2019 5:50 pm
This helped me figure it out. I had the Configure Maps set to Worldwide DEM Basemap. Changing it to Topo US & Canada brought back the surface roads. Thanks for the help.
Always a pleasure!