GPSrChive Discussion Forum

Careful, firmware 10.10 does not show any Waypoints on the map page anymore for me at any zoom level (only my self-created User Waypoints are visible).

What other waypoints are there other than user created waypoints?

Apologies, I was referring to the POIs that come with the map (I am using Garmin TopoActive Americas and Garmin Cycle Map Americas). With previous firmware, certain POI Symbols (washrooms, restaurants, bike repair stations, …) were visible at certain zoom levels - that’s now completely gone with 10.10 on my GPSMAP 66s.

Erhau175 is correct

See screen shots attd from
66st. V10.10. Garmin topo maps. Most detail
And
750t same maps and details

The 10.10 version is not showing WP embedded in the maps
The attd is near me
There is no church, top right or shop and other locations near me

Will have to go back to 9.90 if I can
Mike

I have emailed product support
We will see

Are the settings the same or has the updated firmware altered the settings?

I don’t think any settings were changed
I have now reverted to 9.90. What a pain. Factory reset and re-pairing with phones etc!

MikeD wrote: ↑Thu Jun 02, 2022 5:30 pm I don’t think any settings were changed

Unfortunately, that is not a definitive answer.

I will not be able to test my device until later tonight.

I'm seeing the same issue with firmware 10.10. Embedded POIs are not being displayed on TopoActive or Garmin Cycle maps (regardless of the 'Map Point' zoom level setting). However, they are shown on City Navigator maps.

User POIs and waypoints are displayed OK.

I have two 66s and one 66st. On the 66st, I also have a CN North America NT map on micro SD card installed. I confirmed that prior to updating to 10.10 both the Topo and the CN maps had plenty of POI's such as restaurants, bank machines, transit, etc. To be safe, I removed the CN map card and updated to 10.10. After the update there were zero POI's on the Topo map. I re-installed the CN card and it also shows zero POI's. I then removed the CN card once again and put it into an older 64s whereupon all POI's are displayed as normal. That was a relief as those cards cost $100, lol. One 66s I have has a Open Map Chest {Canada} map card in it which also lost the POI's after the update. My remaining 66s has a CN North America NT card in it as well but I'll not update this unit to 10.10 until Garmin sorts it out. BTW, all settings are still the default map advanced settings. Nothing changed with 10.10 as far as I can tell.