TranslationCould anyone with an Outdoor Maps+ subscription verify the following?
The enabled map layers are not persisted across a power off and power on of my GPSMAP (firmware version 8.80). So for example I have Buildings layer and TopoActive layer enabled. I power off the device, and then power it back on again. Only the TopoActive layer is enabled, the Building layer is disabled.
Not sure if this was introduced with 8.80 or that previous firmware versions had this as well. It would make sense to have the same layers enabled as before powering off, so to me it looks like a bug.
Enabled Map Layers Not Retained [Bug 37]
-
JungleJim
- Posts: 560
- Joined: Sat Mar 05, 2022 3:45 pm
- Location: Netherlands
Enabled Map Layers Not Retained [Bug 37]
Current: GPSMAP H1, inReach Mini 2, Suunto Vertical 2, Wahoo ELEMNT ACE - Previous: GPSMAP 67, inReach Messenger, GPSMAP 66sr, Oregon 700, Dakota 20, Edge 1040, Edge 1030 Plus, Edge 1030, Edge 520 Plus, Edge 520
-
GPSrChive
- Site Admin
- Posts: 4565
- Joined: Fri Jan 20, 2017 11:29 pm
Re: Enabled Map Layers Not Retained [Bug 37]
Absolutely 100% a bug.
Thank you for bringing it to our attention!
Please, everyone, report this bug to Garmin to expedite resolution.
Thank you for bringing it to our attention!
Please, everyone, report this bug to Garmin to expedite resolution.
Visit GPSrChive.com - a premier independent GPS information resource!