Routes with >50 points are stuck at 0% instead of error message?

[ConiKost]

Did anyone also noticed, that loading a route with more than 50 points results in calculation stuck at 0% forever instead displaying an error message, that more than 50 points are not supported? Firmware 19.20.

[Przekątny]

This is the case in all devices, the route determined by roads is limited to 50 intermediate points.

[ConiKost]

This is the case in all devices, the route determined by roads is limited to 50 intermediate points.

Eh? Shouldn't be there instead an error message, which indicates that instead of hanging forever at 0%?

[Przekątny]

Eh? Shouldn't be there instead an error message, which indicates that instead of hanging forever at 0%?

Should......
On some devices, a message reads:
‘Onil 50 points can be used for road navigation
or with similar content.