Page 1 of 1
Routes with >50 points are stuck at 0% instead of error message?
Posted: Sun May 05, 2024 11:29 am
by ConiKost
Did anyone also noticed, that loading a route with more than 50 points results in calculation stuck at 0% forever instead displaying an error message, that more than 50 points are not supported? Firmware 19.20.
Re: Routes with >50 points are stuck at 0% instead of error message?
Posted: Sun May 05, 2024 11:38 am
by Przekątny
This is the case in all devices, the route determined by roads is limited to 50 intermediate points.
Re: Routes with >50 points are stuck at 0% instead of error message?
Posted: Sun May 05, 2024 7:10 pm
by ConiKost
Przekątny wrote: Sun May 05, 2024 11:38 am
This is the case in all devices, the route determined by roads is limited to 50 intermediate points.
Eh? Shouldn't be there instead an error message, which indicates that instead of hanging forever at 0%?
Re: Routes with >50 points are stuck at 0% instead of error message?
Posted: Sun May 05, 2024 7:43 pm
by Przekątny
ConiKost wrote: Sun May 05, 2024 7:10 pm
Eh? Shouldn't be there instead an error message, which indicates that instead of hanging forever at 0%?
Should......
On some devices, a message reads:
‘Onil 50 points can be used for road navigation
or with similar content.